How To Mount a TV Instructions

Assembly Instructions for Sanus LCD Wall Mount Model: VMF

This product is designed to mount VESA 75/100 LCD televisions up to 50 pounds onto a vertical wall. It allows you to effortlessly tilt your new television up to 15° up or down without the use of tools.
Note: The hardware provided is for wood stud walls only. If you are uncertain about the nature of your installation.

Required Tools: Drill with 3/16” bit, Phillips screw driver

Mounting the Wall Plate: The Wall Plate (a) MUST be mounted to a wood stud. Use a high quality stud sensor to locate a stud. It is a good idea to verify where the stud is located with an awl or thin nail. Use the Wall Plate as a template to mark the two hole locations on the wall. Make sure these holes are aligned vertically and centered over the stud. Pre-drill the two holes using a 3/16” drill bit. Attach the Wall Plate to the wall using the two Wall Mount Screws (g) as shown in Diagram 1. Tighten the Wall Mount Screws until they protrude 1/4 inch from the wall. You will firmly tighten the Wall Mount Screws during final assembly.


Attaching the Monitor Plate to the TV: Mount the assembly to the back of your LCD television using the M4 Bolts (h) as shown in Diagram 2. Place the four M4 Bolts through the holes in TV Mount Plate (b) and tighten into the VESA bolt mounting pattern on the back of the television.


mounting pattern on TV Final Assembly: Next hang the assembly over the Wall Mount Screws (g) using the key-holes in the Wall Plate as shown in Diagram 3. Once the Wall Plate slides down over the Wall Mount Screws, firmly tighten them with the Allen Key (j).